Directed-electronics OHV1021 Manuale Utente Scaricare il pdf (Pagina 22)

6. Cut a 1" hole in the headliner along the backside of the mounting bracket for the cables to

pass through.

7. Route cables through the hole to the predetermined location of the AV source(s).

8. Identify the dome light wires in the vehicle and connect them to the corresponding dome light

wires on the overhead monitor system. Ensure the domelight switch is in the correct position.

9. Plug in the AV, DIN, dome light, and power cables into the overhead monitor system.

10. Carefully hold the overhead monitor system to the mounting bracket aligning the mounting

holes while screwing in the screws. (Make sure the wires and cables are not in the way while mount-

ing the monitor).

11. Ground the Black wire of the power cable to a clean ground spot.

12. Connect the Yellow wire of the power cable to the battery positive terminal.

13. Connect the Red wire of the power cable to the Accessory wire in the ignition harness.

NNOOTTEE::

Make sure you keep the ground wire of the monitor and video source as short

as possible to prevent unwanted audio noise pickup from the vehicle’s systems.

Roof Beam Support

Metal Bracket

Optional Spacer Material

(Installer Provided)

Screws

(not included)

Screws

(Included)

1 2 ... 17 18 19 20 21 22 23 24 25 26 27

Nessun commento

Directed-electronics OHV1021 Manuale Utente Pagina 22